How can we improve the excessive waste of lead-free solder paste used every day?

It is used every day on a production lineLead-free solder pasteToo much extravagance and waste. If the solder paste is exposed to the air for too long, the flux will evaporate and the effect will not be very good when passing through the furnace. In addition, lead-free solder paste in the morning may have flux added when it is used in the afternoon. This situation directly affects the quality after my furnace. How can I improve it? The following solder paste manufacturer will explain:

1.SMTMechanical printing

1If it were a single case, it would probably not be too wasteful. It would be better to use it in small amounts and frequently, adding it every two hours. As a result, it won't be so hard during printing, and the effect of scraping will be much better. After passing through the oven, it will be relatively much better. However, there is one point. If you have a relatively long lunch break, you can also put the solder paste back into the bottle to prevent the flux from oxidizing.

2MultipleSMTThe production line uses one bottle of lead-free solder paste. After using it up, another bottle is used. As a result, the time it is exposed to the air is too short. It is not necessary to distribute one bottle in this way for each line. If it is left in this way, it will naturally be wasted. After being exposed to the air for a long time, the solder paste means it is scrapped.

Second, manual printing

If it is printed manually, there might be more extravagance and waste. It is recommended that multiple people use one bottle of solder paste, which can speed up the application of the solder paste and reduce the exposure time of lead-free solder paste to the air. After use, one bottle can be opened to another. In addition, in the case of manual operation, the proficiency of skills should also be enhanced, which can also reduce the wasteful use of solder paste.