If the solder paste reflow soldering causes the board to get stuck, how should it be handled?

In daily lifeSolder pasteDuring the reflow soldering process, sometimes the sheet material gets stuck. In the face of such a situation, it is very important to handle it accurately and on time. Therefore, every executor should master the correct handling method. So, how should we deal with it? Now, JJY solder Paste Manufacturer will explain it to you:

1If there is a blockage, please do not send the board back into the furnace again.

2Please quickly open the furnace cover and take out the plates.

3Seek the root cause and take corresponding measures.

4After reaching the required temperature, please continue with the welding.

When an alarm occurs, welding should be stopped immediately, the cause of the alarm should be checked and dealt with promptly.

1During the reflow soldering process, if there is a power outage, do not send the circuit board back into the reflow oven. inUPSWith the support of the backup power supply, the conveyor belt and chain guide rail will not stop running. After transporting the surface assembly board to the furnace mouth, all the board parts need to be removed, and then the furnace cover should be opened for cooling. The operation should be stopped after the cooling is completed.

2In case of unexpected situations, for exampleUPSWhen a malfunction occurs, a wrench should be used to hold the outlet of the motor's square shaft and rotate it to fix it as soon as possiblePCBMove it out of the furnace.

The above content is shared by Shenzhen JJY Solder Paste Manufacturer for you. We hope it will be helpful to you. If you want to know more about solder paste andSMTKnowledge about surface mount technology (SMT) processing. Welcome to leave a message and interact with us